Makita LS0714 Instruction Manual page 23

1
2
1. Bevel scale
2. Pointer
3. Screw
1. Left 45 degrees bevel angle
adjusting bolt
1
2
3
1. Work piece
2. Cutting line
3. Holder assembly
(optional accessory)
1
2
1. Vertical vise
2. Holder assembly
(optional accessory)
003944
3
(2)
003945
1
Adjusting the position of laser line
For model LS0714FL, LS0714L
005701
WARNING:
• As the tool is plugged when adjusting the position of laser line, take a full
caution especially at switch action. Pulling the switch trigger accidentally
cause an accidental start of the tool and personal injury.
CAUTION:
• Never look into the laser beam directly. Direct laser beam causes
damage to your eyes.
• Never apply a blow or impact to the tool. A blow or impact causes the
incorrect position of laser line, damage to the laser beam emitting part or
a short life of the tool.
• Have the tool repaired by Makita authorized service center for any failure
on the laser unit. No change with different type of laser is permitted.
005702
Make sure that the pointer on the arm point to 0° on the bevel scale
on the arm holder. If it does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so that it will point to 0°.
45° bevel angle
Adjust the 45° bevel angle only after performing 0° bevel angle
adjustment. To adjust left 45° bevel angle, loosen the lever and tilt
the blade to the left fully. Make sure that the pointer on the arm
points to 45° on the bevel scale on the arm holder. If the pointer
does not point to 45°, turn the 45° bevel angle adjusting bolt (upper
bolt) on the right side of the arm until the pointer points to 45°.
23