Makita LS0714 Instruction Manual page 13

ASSEMBLY
1. Wrench holder
2. Pipe holder
1
1. Stopper pin
1
2
3
1. Center cover
2. Socket wrench
3. Hex bolt
4. Safety cover
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Socket wrench storage
003933
The socket wrench is stored as shown in the figure. When using the socket
1
wrench, pull it out of the wrench holder. After using the socket wrench, return it
to the wrench holder.
2
Installing or removing saw blade
003923
CAUTION:
• Always be sure that the tool is switched off and unplugged before
installing or removing the blade.
• Use only the Makita socket wrench provided to install or remove the
blade. Failure to do so may result in overtightening or insufficient
tightening of the hex bolt. This could cause an injury.
Lock the handle in the raised position by pushing in the stopper pin.
To remove the blade, use the socket wrench to loosen the hex bolt holding the
003934
center cover by turning it counterclockwise. Raise the blade guard and center
cover.
4
13