Certification Information; Operating Temperature And Humidity Limits; Signal Words; Warnings And Cautions - Sperian PHD6 Reference Manual

Gas detector
Table of Contents

Advertisement

Appendix C PHD6 Sensor Information
Appendix D Electrochemical Toxic Sensor Cross-Sensitivity
** S
ENSOR MANUFACTURER RATES
PPM
: "S
EXPOSURE
HORT GAS EXPOSURE IN MINUTE RANGE
".S
I
READING
PERIAN
NSTRUMENTATION
S
I
PERIAN
NSTRUMENTATION

Certification Information

The PHD6 carries the following certifications (as of 6/1/2008):
SGS USTC Class I Division 1 Groups A,B,C,D Temp Code T3C (Approved to UL 913)
SGS USTC Class II Division 1 Groups E,F,G (Approved to UL 913)
SGS USTC Class III (Approved to UL 913)
CSA Class I, Division 1 Groups A,B,C,D Temp Code T3C
ONLY THE COMBUSTIBLE GAS DETECTION PORTION OF THIS INSTRUMENT HAS BEEN ASSESSED
FOR PERFORMANCE.
ATEX: Ex d ia IIC 170 °C (T3)
IECEx: Ex d ia IIC 170 °C (T3)

Operating Temperature and Humidity Limits

The Biosystems PHD6's operating temperature range is printed on the
label on the back of the instrument. Use of Sperian Gas Detectors outside of the
instrument's specified operating temperature range may result in inaccurate and potentially
dangerous readings.

Signal Words

The following signal words, as defined by ANSI Z535.4-1998, are used in the PHD6
Reference Manual.
indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
indicates a potentially hazardous situation, which if not avoided, may
result in moderate or minor injury.
CAUTION
used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.

Warnings and Cautions

1.
the detection of dangerous atmospheric conditions. An alarm condition indicates the
presence of a potentially life-threatening hazard and should be taken very seriously.
Failure to immediately leave the area may result in serious injury or death.
2.
established procedures. The safest course of action is to immediately leave the affected
area, and to return only after further testing determines that the area is once again safe
for entry. Failure to immediately leave the area may result in serious injury or death.
3.
alkaline batteries are removed from the alkaline battery pack. Removal of the alkaline
batteries from the battery pack in a hazardous area may impair intrinsic safety.
4.
E91-LR6, Eveready EN91 batteries in the alkaline battery pack. Substitution of batteries
may impair intrinsic safety.
5.
with new batteries and do not mix batteries from different manufacturers.
6.
appropriate Sperian PHD6 charger. Standard versions of the PHD6 must be charged
C
S
ROSS
ENSITIVITY FOR
W
G
ARRANTY
AS
W
G
D
ARRANTY
AS
ETECTION
The PHD6 personal, portable gas detector has been designed for
In the event of an alarm condition it is important to follow
The PHD6 must be located in a non-hazardous location whenever
Use only Duracell MN1500 or Ultra MX1500, Eveready Energizer
To reduce the risk of explosion, do not mix old or used batteries
Do not charge the PHD6 with any charger other than the
4
HCN
H2S
SENSOR TO
;
AFTER FILTER SATURATION
D
P
ETECTION
RODUCTS
P
RODUCTS
30
30
20
AS FOLLOWS FOR
:
. 40 PPM
CA
30
31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PHD6 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents