Control For Hdmi - Sony DAV-TZ210 Operating Instructions Manual

Control for HDMI

Symptom
The Control for HDMI function
does not work.
No sound is output from the
system and TV while using the
System Audio Control function.
Messages
Symptom
"PROTECTOR" and "PUSH
POWER" appear alternately.
"OVERLOAD," "REMOVE
USB," then "PUSH POWER"
appear.
"LOCKED" appears and a disc
cannot be ejected.
"DATA ERROR" appears.
"READING" is displayed for a
long time while playing.
68
GB
Downloaded From TheatreSystem-Manual.com Manuals
Problems and solutions
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 58).
• Make sure that the connected component is compatible with the [CONTROL
FOR HDMI] function.
• Check the connected component's setting for the Control for HDMI function.
Refer to the operating instructions of the component.
• If you change the HDMI connection, connect and disconnect the AC power
cord (mains lead), or have a power failure, set [CONTROL FOR HDMI] in
[HDMI SETUP] to [OFF], then set to [ON] (page 58).
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 49).
• Make sure that the connected TV is compatible with the System Audio Control
function.
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 49).
Problems and solutions
• Press "/1 to turn off the system, and check the following items after
"STANDBY" disappears.
– Are the + and – speaker cords short-circuited?
– Is anything blocking the ventilation holes of the system?
– After checking the above items and fixing any problems, turn on the system.
If the cause of the problem cannot be found even after checking all the above
items, consult your nearest Sony dealer.
• A problem has been detected with the level of electrical current from the
(USB) port. Turn off the system and remove the USB device from the
(USB) port. Make sure there is no problem with the USB device. If this display
pattern persists, contact your nearest Sony dealer.
• Contact your Sony dealer or local authorized Sony service facility.
• The file you want to play is broken.
• The file format does not match the extension of the file name. See "Playable
Discs/Files on a USB Device" (page 6).
• The JPEG image file format does not conform to DCF.
• The reading process can take a long time if:
– there are many folders or files on the USB device.
– the folder or file organization structure is very complex.
– the memory capacity is very large.
– the internal memory is fragmented.