Pioneer KJR-12B/DP(T)-F-1 Installation Manual page 6

Installation Method
1. Remove the top panel of remote control
Insert a screwdriver into the two slots at the bottom of
the remote control to pop off the top panel.
Slots
Fig. 8
NOTE: The Printed Circuit Board (PCB) is mounted in the
upper part of the remote control. Be careful not to damage
the board with the screwdriver.
2. Mount the back plate of the remote control
a. For exposed mounting, fasten the back plate to the
wall with 3 screws (M4×20) and anchors.
b. For flush mounting, fasten the back plate to the switch
box with 2 screws (M4×25), and fasten the switch box
to the wall with 1 screw (M4×20).
NOTE: Place the unit on a flat surface. Be careful not to
distort the back plate of the remote control by over
tightening the screws.
8
9
Back plate
Screws (M4×20)
Fig. 9
Switch box
Back plate
Screw (M4×20)
Screws (M4×25)
Fig. 10