Table of Contents
Wall-Mounted Remote Control Wiring...............................1
Wall-Mounted Remote Control Installation ........................6
Wall-Mounted Remote Control Wiring
WARNING
The wiring should adapt to the wire control current.
•
Otherwise, electric leakage or overheating may occur
and result in fire.
The specified cables shall be used in the wiring. No
•
external force may be applied to the terminal.
Otherwise, the wire may be damaged and heating may
occur and result in fire.
CAUTION
The shielded wire must be grounded.
•
The connecting cable should not be longer than 20m (65.5').
•
The remote control operates on a low voltage circuit
•
loops. DO NOT connect a 220V or 380V cable to the
circuit loop.
Make sure that configured tubes are 30-50cm (12-20")
•
or more apart.
DO NOT employ an ohmmeter to detect the insulation
•
after wiring the remote control.
1