Default Values - Datalogic FireScan D131 Quick Reference

PEN READER CONFIGURATION
Read the restore default code, and then read the PEN interface
selection code.

DEFAULT VALUES

USB DEFAULT SETTINGS
DATA FORMAT
code length not transmitted, character replacement disabled.
USB KEYBOARD
character and inter-code delays disabled, control character
emulation = ctrl+shift+key.
: no handshaking, delay disabled, rx timeout 5 sec.,
USB COM
ack/nack disabled, FIFO enabled, serial trigger lock disabled.
Default Headers and Terminators for each USB mode:
-
USB-KBD: no header, terminator = ENTER
-
USB-KBD-ALT-MODE: no header, terminator = CR
-
USB-COM: no header, terminator = CR-LF
-
USB-IBM-TABLE TOP: not applicable
-
USB-IBM-HAND HELD: not applicable
RS232 Standard DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled.
RS232 Nixdorf DEFAULT SETTINGS
9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking
hardware (RTS/CTS), delay disabled, rx timeout 9.9 sec.,
ack/nack disabled, FIFO disabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
RESTORE DEFAULT
Ì$+$*oÎ
Ì$+CP6$-BÎ
: code identifier disabled, no field adjustment,
: USA keyboard, FIFO enabled, inter-
: code identifier disabled, no field adjustment,
: code identifier enabled, no field adjustment,
PEN