Honda NC700X Owner's Manual page 92

Tyre Puncture u
5. Remove the rear axle shaft, washers,
brake caliper bracket, rear wheel and side
collars.
u Support the brake caliper assembly so
that it doesn't hang from the brake
hose. Do not twist the brake hose.
Avoid getting grease, oil, or dirt on the
u
disc to pad surfaces.
u Do not push the brake pedal while the
wheel is removed.
Installation
1. To install the rear wheel, reverse the
removal procedure.
u Take care to prevent the brake caliper
from scratching the wheel during
installation.
88
Removing Wheels
NOTICE
When installing the brake caliper into position, carefully
fit the brake disc between the pads to avoid scratching
them.
2. Make sure that the slot on the brake
caliper bracket is positioned in the lug on
the swingarm.
Brake caliper
bracket
Swingarm
Lug
Slot