Table of Contents
Advertisement
3.4 Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. Refer to
precautions when mounting the drive:
• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 inch (3.81mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 inch-lb).
Figure 2 Mounting dimensions (2TB and 4TB)
4.010 in
max
101.85 mm
1.140 ± .050 in
28.96 ± 1.27 mm
1.22 ± .020 in
1.122
30.99 ± .51 mm
28.50
3X 6-32 UNC-2B
3 MIN THREAD DEPTH
0.15 MAX FASTENER PENETRATION
MOUNTING HOLES
BOTH SIDES
Seagate NAS HDD +SRS Product Manual, Rev. C
for drive mounting dimensions. Follow these important mounting
Figure 2
5.787 in max
146.99 mm
4.00 in
101.60 mm
1.638 in
41.61 mm
5
TYP
C L
OF CONNECTOR
DATUM B
Temperature
C L
Check Point
OF DRIVE
TOP OF LABEL
0.680 ± .050 in
17.27 ± 1.27 mm
1.028 in max
26.11 mm
3x 0.250 ± .010 in
6.35 ± .25 mm
BOTH SIDES
0.138 in
3.51 mm
0.814 in
20.68 mm
22
Advertisement
Table of Contents
