Mechanical Instructions - Philips LC4.41E Service Manual

4. Mechanical Instructions

Index of this chapter:
4.1 Cable Dressing
4.2 Service Position
4.3 Assy/Panel Removal
4.4 Set Re-assembly
4.1 Cable Dressing
4.2 Service Position
First, put the TV set in its service position. Therefore, place it
upside down on a table top (use a protection sheet or foam
bars).
4.2.1 The Foam Bars
Required for sets
1
42"
Figure 4-2 Foam bars
The foam bars (order code 3122 785 90580) can be used for
all types and sizes of Flat TVs. By laying the plasma TV flat on
the (ESD protective) foam bars, a stable situation is created to
perform measurements and alignments. By first placing a
Mechanical Instructions
Figure 4-1 Cable dressing
4.3
4.3.1
1
E_06532_018.eps
171106
LC4.41E AA
Notes:
• Figures below can deviate slightly from the actual situation,
due to the different set executions.
• Follow the disassembling instructions in described order.
mirror flat on the table under the TV you can easily see if
something is happening on the screen.
Assy/Panel Removal
Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Remove the screws that secure the rear cover.
2. Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
4. EN 7
G_16240_011.eps
150206