Setting Up The Machine For Brewing A Cup Of Coffee - Bella 14405 Instruction Manual

SETTING UP THE MACHINE FOR BREWING A CUP OF COFFEE

The drip tray adjusts to two heights to accommodate shorter cups or mugs to taller travel mugs/tumblers.
For taller travel mugs and tumblers, make sure the drip tray and cover are properly placed in the lower
position (See Figure 2 ) When brewing a smaller cup, raise the drip tray to the upper level to avoid splatter
(See Figure 4 )
Adjusting The Drip Tray
1. Grasp the drip tray and cover from the base cut-outs. (See Figure 2.)
2. Holding on to both pieces, slightly tilt upwards and slide out from the unit. (See Figure 3.)
3. Using the tab on the back of the drip tray as your guide, again slightly tilt both pieces upwards and glide
the tabs into the upper slots on the Coffee Maker body. (See Figure 4.) Press down on the drip tray with
your hand to make sure it is firmly and properly attached before placing the cup or mug on top.
Figure 2
Setting up the machine using the capsule adaptor
WARNING: Before brewing, it is recommended the water tank be filled at least to
the lowest 6-oz. step. To avoid damage to your Coffee Maker, never operate your
Single Serve Coffee Maker when the water tank is empty.
1. Lift the water tank lid located at the top back of the unit (see Figure 1.)
2. Using the desired cup, mug, or tumbler as your measure, add water to
the water tank. The water tank has an easily visible, stepped water level
indicator. Add water to the desired fill line to brew one cup of any hot
beverage. The level indicator marks 6-oz., 10-oz., and 15-oz. However, any
amount of water may be added. DO NOT EXCEED the 15-oz. MAX fill line.
3. Lower the lid.
IMPORTANT: For optimal flavor, distilled water is preferred.
4. Position the cup under the nozzle and onto the center of the
drip tray cover.
5. Pull the adaptor compartment's front tab up to unlock and lift the lid.
6. Choose the capsule adaptor. With the handle facing front, place the capsule
adaptor into the adaptor compartment. Slide the adaptor handle into the
grooves at the front of the Coffee Maker (See Figure 5.)
7. Add the capsule of your choice into the capsule adaptor.
8. Press the adaptor compartment's lid down firmly. An audible click can be
heard as the lid is locked firmly into position. Both the top and bottom of the capsule will be punctured.
9. Plug the Coffee Maker into a 120V AC electrical wall outlet.
10. Press the CAPSULE button to begin the brew cycle.
11. The red HEATING indicator light will begin to flash as the Coffee Maker begins heating the water.
12. When the water has reached the optimum temperature, the heating light will go out and the blue
BREWING light will illuminate.
13. The pump will then activate and coffee will begin to stream through the nozzle.
14. To interrupt the brewing cycle at any time, press the CAPSULE button. Then remove the plug from
the wall outlet.
15. At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF.
16. Allow unit to cool before removing the used capsule to discard.
17. Unplug the Coffee Maker when not in use.
Figure 3
Upper
Slots
Base
Cut
-Outs
10
Figure 4
Figure 5
Capsule