Sony XAV-A1 Service Manual page 7

JIG ON REPAIRING
• When repairing this set, etc., connect the extension cable as the figure shown below.
extension cable (34P) (Part No.: J-2502-098-1)
(LCD board (CN1006)-SLIDER board (CN2))
LCD board
(CN1006)
HOW TO PULL OUT MONITOR BLOCK IN CASE ELECTRICITY DOES NOT CIRCULATE
• When monitor block does not open by fault, pull out monitor block in the following procedures.
6 stopper washer
7 gear (1 S)
B
3 Rotate the worm gear in the direction of arrow B .
for pulling the monitor block.
Note: Don't touch except the gray portion of worm gear.
SLIDER board
(CN2)
SLIDER board
(CN1)
(gear 1)
extension cable (53P) (Part No.: J-2502-097-1)
(MAIN board (CS602)-SLIDER board (CN1))
MAIN board
(CS602)
A
4
8 Pull the monitor block.
XAV-A1
1 two screws
(M2)
5 bracket (slider)
2 Open the bracket (slider)
in the direction of arrow A .
7