Olympus FE-120 Advanced Manual page 114

Troubleshooting
Possible cause
The center of the subject
is too bright.
Bright subjects such as
snow will turn out darker
than their natural colors
in the image.
The colors of pictures look unnatural.
Indoor lighting affected
the picture's colors.
No white in the picture.
The white balance
setting is wrong.
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures in
internal memory or card.
There is a problem with
the card.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
9
protected.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
114
Corrective action
If the center of the subject is too bright, the
image as a whole emerges darker. Adjust the
exposure compensation toward plus (+).
Adjust the exposure compensation toward
plus (+).
Set the white balance according to the
lighting.
Include something white in the picture, or
shoot using [#].
Adjust the white balance according to the
light source.
Hold the camera correctly, keeping your
fingers and the strap away from the lens.
Press $ to turn the camera on in playback
mode.
Press $ to switch to playback mode.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error codes".
Cancel the protection of the pictures.
Use [s] to adjust monitor brightness.
Block the sunlight with your hand.
Ref.
page
P. 44
P. 44
P. 46
P. 42
P. 46
P. 23
P. 10
P. 10,
11
–
P. 108
P. 64
P. 75
–