Olympus FE-120 Advanced Manual page 111

Possible cause
There is a problem with
the card.
The monitor is hard to see.
There is condensation*
inside the camera.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Vertical lines appear on
the monitor screen
during shooting.
The date recorded with the image data is wrong.
The date/time is not set.
The camera has been
left without batteries.
The settings are returned to the factory default settings when the camera is turned
off.
[ALL RESET] is set to [ON]. Set [ALL RESET] to [OFF].
The picture is out of focus.
The subject was too
close.
Auto focus is not
possible.
There is condensation*
on the lens.
Corrective action
See "Error codes".
Turn the camera off and wait until it dries
before turning it on again.
Use [s] to adjust monitor brightness.
Block the sunlight with your hand while taking
pictures.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction.
Set the date/time. The clock adjustment is
not factory-preset.
If the camera is left without batteries for 3
days, the date/time setting is canceled. Set
the date/time again.
Move further away from the subject. To take
pictures closer than 20 cm (7.9") with the
zoom in the maximum wide position, use the
super macro mode.
Use the focus lock to focus on your subject.
Turn the camera off and wait until it dries
before turning it on again.
Troubleshooting
Ref.
page
P. 108
–
P. 75
–
–
P. 76
P. 76
P. 70
P. 41
P. 24
–
111
9