Sanyo VCC-HD2300 Instruction Manual page 15

If video is out of focus in either color or black-and-white mode, perform the following steps to adjust
the focus.
1 Confirm that [COLOR/B/W] is set to "AUTO" under [FOCUS ASSIST] on the CAMERA SETTINGS
screen.
2 Adjust the focus in color and black-and-white mode, respectively.
If you are using an optical zoom lens and zooming operation causes the camera to lose focus, adjust the flange
back distance as follows.
1
Press the SET button for 2 seconds or more.
The monitor now shows the SELECT MENU screen.
On the SELECT MENU screen, all information is displayed in English.
2
Select [FOCUS ASSIST] using the NEAR/FAR button and press the SET button.
The monitor now shows the focus adjustment screen.
3
Use the zoom and focus levers of the lens to focus on the subject at the telephoto end
and press the NEAR/FAR button to adjust the focus.
Pressing the button causes the back focus position to change, which is indicated in the FB bar gauge (
The position changes step by step each time the button is pressed and continuously at a high speed when the
button is held down.
4
Use the zoom and focus levers of the lens to focus on the subject at the wide end and
press the NEAR/FAR button to adjust the focus.
Repeat the above steps until switching between the telephoto and wide ends does not cause the camera to lose
focus.
C
).
Introduction 15/17