Installation Of The Tilting Detect Switch; Installation Of The Eye Guard - Mitsubishi Electric PLK-G1010 Technical Manual

<9>
<8>

3-8. Installation of the tilting detect switch

(1) Install the switch units (No.1) with the SW-MW screws (No.2) so that the switch turns on when the
machine head in initial position is pushed by the machine table.
[Notice] if the switch is not turned on, error [M-038] will occur.

3-9. Installation of the eye guard

(1) Loosen the SW-MW screws (No.2) on the eye guard unit (No.1) then, mount the SW-PW screws
(No.3) to the flat place of the sewing machine with the open guard.
(2) Return the open guard to the initial position then, tighten the SW-MW screws (No.2).
<2>
<1>
<3>
<3>
<2>
<1>
<7>
<6>
<1>: Switch units
<2>: SW-MW screw (two screws)
<1>: Hinge shaft (two shafts)
<2>: Set screw (two screws)
<3>: Hinge (two hinges)
<4>: Hinge rubber (two rubbers)
<5>: Support plate (two plates)
<6>: Socket bolt (four bolts)
<7>: Flat washer (four washers)
<4>
<8>: Head rest
<5>
<9>: Safety socket bolt (four bolts)
<1>: Eye guard unit
<2>: SW-MW screw
<3>: SW-PW screw (two screws)
- 6 -
<1>
Snap!
<2>