Olympus CAMEDIA D-630 ZOOM Advanced Manual page 112

Troubleshooting
Possible cause
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
(When the camera is connected to a computer or printer
Possible cause
The printer fails to connect.
[PC] was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
The printer does not
support PictBridge.
The camera is not recognized by the computer.
The computer failed to
recognize the camera.
The USB driver has not
been installed.
9
112
Corrective action
Use [s] to adjust monitor brightness.
Block the sunlight with your hand.
Corrective action
Remove the USB cable, and start again from
Step 1 of "Printing pictures".
Refer to the printer's instruction manual or
contact the manufacturer.
Disconnect the USB cable from the camera,
and connect it again.
Install OLYMPUS Master.
Ref.
page
P. 72
–
Ref.
page
P. 76
–
P. 76
P. 91