SECTION 501-20A: Safety Belt System
GENERAL PROCEDURES
Replacement of the Weld Nut and Reinforcement
1. NOTE: The following is for Coupe, Front and Rear, and Convertible rear only.
NOTE: If the safety belt anchor nuts or reinforcements are stripped or missing, a new
nut/reinforcement plate must be installed.
Expose the suspect anchor point.
2. Drill out two 8 mm (0.32 in) (5/16 inch) diameter access holes adjacent to the weld nut
clearance hole.
3. Thread a length of copper welding wire through the clearance hole and position to secure the
weld nut and washer.
4. Use MIG wire feed welder and plug weld a 7/16 inch weld nut and standard washer in place at
the two 8 mm (5/16 inch) holes.
5. Metal finish as necessary.
6. Install the restraint system.
7. Carry out the Functional Test. For additional information, refer to
section.
2003 Mustang Workshop Manual
Safety Belt System
in this