Step E - Turn On Water, Check For Leaks And Rinse Carbon Fines - Whirlpool WHADUS5 Installation And Operation Manual

continued from the previous page
Connect Tubing:
1. Use a sharp cutter or knife to cut the end of tubing square.
2. Inspect the end (about 1") of the tubing to be sure there are no nicks, scratches or other rough spots.
If needed cut the tubing again.
3. Push tubing through the collet and all the way into fitting. Full engagement is 3/4" length of tube into
the fitting.
If tubing other than supplied with the system is used, be sure it is of high quality, exact size and round-
ness with a smooth surface.
To Disconnect Tubing:
1. Push the collet inward and hold with a finger while pulling the tubing out.

Step E - Turn On Water, Check for Leaks and Rinse Carbon Fines

1. Open the shutoff valve(s) that you closed at the beginning of this installation.
2. Open the sink faucet and filtered water faucet to purge air from the system. When the water runs
smooth, with no bubbles or spurting, close faucets and check installation for leaks.
3. Open the filtered water faucet and let water run for 10 minutes to rinse out carbon fines.
Questions? Call Toll Free 1-866-986-3223
When you call, please be prepared to provide the model number and date code,
Installation Instructions
Tubing correctly cut and connected
end of tubing round and smooth,
with no cuts, nicks or flat spots
Incorrect partial engagement
collet (depress to remove tubing)
tubing
or visit whirlpoolwatersolutions.com
found on the rating decal on back.
correct full 3/4" engagement
Monday- Friday, 7 AM - 6 PM CST
9
FIG. 5
FIG. 6