Start A Clean Rinse Cycle; Set Number Of Days Between Clean Rinse Cycles; Set Clean Rinse Time; Set Length Of Clean Rinse - Whirlpool WHELJ1 How To Install, Operate And Maintain

Customizing Features I Options

START A CLEAN RINSE CYCLE

To manually start a Clean Rinse cycle, press and hold the CLEAN button for a few seconds, until
"RECHARGE NOW" flashes in the display.

SET NUMBER OF DAYS BETWEEN CLEAN RINSE CYCLES

By default the Central Water Filtration System will automatically initiate a Clean Rinse every 14 days.
This should be sufficient for most applications.
To change the number of days between Clean Rinse cycles:
Press the PROGRAM button twice, so "RECHARGE" is shown in the display.
Press the UP or DOWN buttons to set the number of days between Clean Rinse cycles (from I to 99).
Press the PROGRAM button twice when complete.

SET CLEAN RINSE TIME

By default the Central Water Filtration System will Clean Rinse at 1:00 a.m.
To change the Clean Rinse start time:
Press the PROGRAM button three times, so "RECHARGE TIME" is shown in the display.
Press the UP or DOWN buttons to set the Clean Rinse time. Be sure AM or PM is correct.
Press the PROGRAM button again when complete.

SET LENGTH OF CLEAN RINSE

By default the Central Water Filtration System's Clean Rinse cycle will consist of a 2 minute backwash
followed by a 1 minute fast rinse. This should be sufficient for most applications.
Increasing the length of Clean Rinse time will increase the amount of water flushed to drain during each
Clean Rinse cycle, therefore, these times should only be increased when necessary.
To change the length of the backwash part of the Clean Rinse cycle:
Press and hold the PROGRAM button for a few seconds, until the "000" screen appears,
Press the PROGRAM button once, so "bA TIME" appears in the display.
Press the UP or DOWN buttons to set the length of backwash in minutes.
Press the PROGRAM button twice when complete.
To change the length of the fast rinse part of the Clean Rinse cycle:
Press and hold the PROGRAM button for a few seconds, until the "000–" screen appears.