Step F - Connect Tubes - Whirlpool WHAPSRO Installation And Operation Manual

Step F - Connect Tubes (cont.)
Water Supply
Fitting
HOT COLD
NOTE: Tube colors
match collet colors.
ROUTE YELLOW TUBE TO STORAGE TANK
1. Locate the yellow tube attached to the Reverse Osmosis
filter assembly.
2. Remove shipping cap from the loose end of the yellow
tube. Route yellow tube to the fitting on top of the storage
tank. See Fig. 21.
3. Cut tube square and to length. See Fig. 16.
4. Do not connect at this time. This will occur in the sanitizing
step.
CONNECT GREEN TUBE TO COLD WATER
SUPPLY PIPE
1. Locate the 1/4" green tube attached to the Reverse
Osmosis filter assembly.
2. Remove shipping cap from the loose end of the green
tube. Route green tube to the fitting on the water supply
pipe. See Fig. 21.
3. Cut tube square and to length. See Fig. 16.
4. Connect to cold water supply fitting. See Fig. 6.
5. Insert all the way into the fitting. See Figs. 17 & 18.
6. Pull on the tube to be sure it is held firmly in the fitting.
3/8" BLACK
Tubing
Drain
Adaptor
Sink P–
Trap
Tube Connections
14
Tubing Connector
(Shutoff valve)
CONNECT BLACK TUBE FROM REVERSE
OSMOSIS FAUCET TO DRAIN ADAPTER
1. Locate the 3/8" black tube attached to the faucet. Fig 21.
2. The loose end needs to be attached to the black collet on
the sink drain adapter.
3. Route it as straight as possible, without loops, dips, or
kinks.
4. Cut the end of the tube square. See Fig. 16.
5. Insert all the way into the fitting. See Figs. 17 & 18.
6. Pull on the tube to be sure it is held firmly in the fitting.
RED TUBE TO REVERSE OSMOSIS FAUCET
The red tube connection was completed in the faucet
assembly steps.
BLUE TUBE TO REVERSE OSMOSIS FAUCET
The blue tube connection was completed in the faucet
assembly steps.
OPEN CLOSED
FIG. 21