Stand - Alone Operation - Martin RoboColor Pro 400 User Manual

S -
TAND ALONE OPERATION
The RoboColor Pro 400 may be operated in stand-alone mode without a controller.
Music-trigger uses a built in microphone for sound-activated control and auto-
trigger runs at a preset speed using an internal trig source.
1 Use the DIP-switch on the rear panel to select a trigger type. To select music-
trigger, set DIP-switch pins 1, 2, and 10 to ON. To select auto-trigger, set DIP-
switch pins 2 and 10 to ON. Set all other pins to OFF.
2 Switch on the unit to perform the chosen program.
Note: Some programs shown below are for service use only. Do not use them for
light shows.
Program
Protocol auto-detect (DMX 512 / Martin RS-485)
Stand Alone Auto-trig
Stand Alone Music-trig
Lamp ON (for lamp adjustment)
Mechanical stop (for service use only)
Adjustment (for service use only)
L.E.D. Chase Auto-trig (for service use only)
L.E.D. Chase Music-Trig (for service use only)
Table 1: Stand-alone program settings
Pin(s) switched ON
All pins switched ON
2, 10
1, 2, 10
8, 10
5, 10
1, 5, 10
4, 10
1, 4, 10
4
7