After Site Survey - Panasonic KX-NCP0158 Quick Installation Manual

6 After Site Survey

6 After Site Survey
After obtaining the proper measurement results, exit Radio Signal Test mode by following the procedure below,
before registering the CS to the PBX.
1.
Hold down the POWER button on the PS until the PS is off.
2.
Disconnect the CS from the AC adaptor, battery, PoE hub, or PoE adaptor to stop supplying electricity.
[Disconnecting the AC Adaptor or Battery]
Notice
Be sure to attach the cover to the DC jack after disconnecting the CS from the AC adaptor or battery.
To AC Adaptor
KX-A421 (PQLV216)/
Battery
[Disconnecting the PoE Hub or PoE Adaptor]
38 Quick Installation Guide
To PoE Hub/PoE Adaptor
Ethernet Straight Cable
Cover