Dyna-Glo DGW1235BDP-D Manual page 10

ASSEMBLY INSTRUCTIONS
3. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the unit
upright on its legs on a firm and level surface.
(Make sure that legs are attached). Place the
upper (P) and lower (Q) doors back onto the
hinges of the smoker body (G) and close the doors.
Position the square smoke stack (A) with control
arm to the left as shown. Using 4 screw (AA),
attach square smoke stack (A) to the top of smoker
body (G). Securely tighten with a Phillips screwdriver.
Hardware Used
AA
M6x12 Screw
4. Attach support bracket (K) to smoker body (G)
using four M6x12 screw (AA).
Repeat for remaining bracket (K).
Hardware Used
AA
M6x12 Screw
3
G
x4
4
x8
10
AA
A
Control
arm
AA
G
K