Advertisement
Figure 26
| Fathom IWS
Figure 25
Install surrounding wallboard flush
against wallboard template.
Figure 27
PRO-TIP
Installing the Wallboard
You may now proceed with
installing the surrounding wallboard
using the wallboard template as a hard
edge. The surrounding wallboard
should be installed flush against
the wallboard template on all sides.
(Figure 25)
Please note, it is critical that any
gaps between the wallboard template
and surrounding wallboard do not
exceed 1/8-inches (0.125 in/3.2 mm).
Removing the Wallboard Template
Once the surrounding wallboard
has been installed, verify that any gaps
between the wallboard template and
surrounding wallboard are no more
than 1/8-inches (0.125 in/3.2 mm).
Use joint compound to fill in any
spaces greater than 1/8-inches (0.125
in/3.2 mm).
To remove the wallboard template,
remove all twelve screws (4 inner and
8 outer) from the wallboard template
and pull forward
(Figure 26 & 27)
detach it. Note, there are four pins
behind the wallboard template used
for alignment with the enclosure, so
the template must be pulled straight
and away from the enclosure without
tilting for removal.
Once removed, any remaining pins
attached to the front of the enclosure
can be removed using pliers.
PRO-TIP:
You may find it easier to partially
screw two screws into the center area
of the template to use as a grip as you
pull forward.
to
Page 15
Advertisement
