Advertisement
to position each screw near the center
of each slotted opening,
(Figure 5)
the bracket needs to be able to shift
left to right within the stud bay.
The centering template has two
stepped window openings
that allow you to visually center
6)
the mounting bracket within the
wall cavity, without taking tedious
measurements. Viewing the stepped
windows as a guide, center the
mounting bracket assembly between
the inside edges of the left and right
wall studs. Once you have the same
position in both stepped windows,
tighten the two screws in the slotted
openings completely and install the
two remaining screws below to hold in
place.
(Figure 7)
With the mounting bracket
centered, slide each steel L-bracket
until the foam padding is firmly
pressed against the inside of each
stud, and secure in place using six #8
x 1.25-inch screws in each L-bracket.
Lock the mounting
(Figures 8 & 9)
bracket in place by tightening the two
pre-attached screws in the slotted
holes of each L-bracket.
(Figure 10)
not install the remaining two screws
in each L-bracket at this time.
Once the mounting bracket is
firmly in place, remove the seven
screws along the front of the centering
template.
The template is no
(Figure 11)
longer needed.
Page 12
as
(Figure
Do
Figure 5
Figure 7
Figure 8
Figure 10
Figure 6
Stepped Windows
for Centering
Figure 9
Figure 11
| Fathom IWS
Advertisement
