Advertisement
Spacers and
padding will vary to
ensure a proper fit.
"A" Box
"B" Box
| Fathom IWS
THE ENCLOSURE
The Fathom IWS enclosure is designed to suspend from a single anchor
point inside the wall cavity of 16-inch, on-center stud (aluminum or wood)
construction homes. Once installed, the enclosure will "hang" snugly within
the wall cavity. The enclosure has various spacers and padding applied to
specific areas, allowing it to only make gentle contact with its surrounding
wallboard surfaces. The placement and amount of pressure applied by these
pads is a critical design aspect to ensure proper fit and should not be altered
in any way. Failure to use the proper enclosure and/or alteration of the spacers
and padding will result in loss of performance and unwanted wall vibrations.
The Fathom IWS uses two enclosure types, referred to as the "A" box
and the "B" box. The "A" box is designed for 2 x 4 stud construction,
and the "B" box is designed for 2 x 6 stud construction.
Enclosure Type
"A" Box
"B" Box
*Dimensions listed are approximate and do not include various spacers and padding.
Furthermore, depending on the actual stud dimensions, there are variations
available for each enclosure type. We strongly recommend measuring your actual
stud dimensions to verify you have the correct enclosure for your application (see
chart below).
"A" Box Enclosure Variations for 2 x 4 Stud Construction
Actual Stud Width
3 1/2-inches (89 mm)
3 5/8-inches (92 mm)
4-inches (102 mm)
"B" Box Enclosure Variations for 2 x 4 Stud Construction
Actual Stud Width
5 1/2-inches (140 mm)
6-inches (152 mm)
Enclosure Dimensions*
70-inches x 13.75-inches x 2.9-inches
(1778 mm x 349 mm x 74 mm)
55-inches x 13.75-inches x 4.7-inches
(1397 mm x 349 mm x 119 mm)
Enclosure Model
IWEv2-113A-3.50
IWEv2-113A-3.63
IWEv2-113A-4.00
Enclosure Model
IWEv2-113B-5.50
IWEv2-113B-6.00
SKU
96093
96094
96095
SKU
96096
96097
Page 5
Advertisement
