Ttl Auto - Olympus FL-36 Instruction Manual

<TTL AUTO>
In this mode, pre-flash is performed to measure the optimum flash intensity and then actual flash is
performed.
1.
TTL AUTO indicator
ZOOM indicator
Displayed according to the
focal length of the lens.
2.
3.
Light control range
22
The control panel shows the light control range according
to the camera setup.
Confirm that the distance to the subject is within the light
control range.
If not, adjust the lens iris (F) or the subject distance.
The light control range varies according to the camera type
and camera setup (ISO speed, lens iris (F) and lens focal
distance (ZOOM)).
When flash activation has been performed correctly, the
AUTO CHECK lamp blinks for about 5 seconds after the
shutter is released.
Light intensity adjustment
The flash light intensity can be adjusted between +3 and –3.
The light intensity adjustment must be set to ON in the
custom setup operation (page 47).
• The
1.
Turn the select dial to choose a light intensity adjustment value.
2.
The display shows the light intensity adjustment value ex-
cept when the value is 0. In this case, the displayed light
control range corresponds to an adjustment value of 0.
3.
If the camera's flash adjustment mode is selected, the
actual flash light intensity will be the total of the light
Light intensity adjustment value
intensity adjustment value set on the FL-36 and that
set on the camera. The light intensity adjustment value
displayed is that of the FL-36 only.
[Example]
indicator appears in the control panel.
0 → +0.3 → +0.7→ +1.0 ... +3.0
0 → –0.3 → –0.7→ –1.0 ... –3.0
Selected Adjustment value Actual light intensity
adjustment value displayed on FL-36 adjustment
FL-36 +0.3
+0.3
Camera +0.3
+0.6
23