Insertion Of Silica Gel; Make Sure The Camera Is Loaded Properly - Olympus PT PT-036 Instruction Manual

For the digital camera m760/stylus 760
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 40

Insertion of silica gel

Before sealing the Case, insert the
silica gel bag provided for
prevention of fogging between the
bottom of the camera and the Case.
EN
CAUTION:
• Insert the silica gel all the way at the specified location and with the
specified orientation. When the orientation is not correct, the silica gel bag
will be caught when the Case is sealed and water leakage will occur.
• If the Case is sealed without inserting the silica gel fully, the silica gel bag
will be caught by the O-ring and water leakage will occur.
• Once silica gel has been used, the moisture absorption performance will
be impaired. Always replace the silica gel when the Case is opened and
closed.

Make sure the camera is loaded properly.

Check the following points before sealing the Case.
• Is the digital camera loaded properly?
• Is the mode dial set to "SCN"?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-ring or the O-ring contact
surface on the front lid?
• Is the waterproof function maintenance performed?
EN 18
Pay attention to the orientation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-036

Table of Contents