Pioneer RCS-LX60D Operation Instructions Manual page 11

• When connections are completed, adjust the cable
placements. If the speakers have been fixed with the
brackets, fix the cable to the groove in the brackets as
shown.
1 ページ ２００７年４月２４日 火曜日 午後７時５７分
up
DD/DVD recorder to the receiver
• Fasten the cables together with the spiral wrap.
Hold multiple cables together and place the wrap
l cable into the CONTROL OUT jack
over the cables from the end.
he receiver subwoofer.
Wrap the spiral wrap with the cables in the center.
The spiral wrap may be cut at a desired length.
nd of the cable into the CONTROL IN
of the HDD/DVD recorder.
l cable into the DIGITAL AUDIO
VR 1) jack on the rear of the receiver
end of the cable into the DIGITAL
OAXIAL) jack on the rear of the HDD/
s the control cable is connected, you
ote control with the HDD/DVD recorder.
cers to the display unit and connect.
difficult to view, the spacers can be
hanging of the viewing angle. Peel off
r from the spacers and press the
pressions on the bottom of the display
nd of the display cable into the
ar of the display unit, then plug the
play cable into SYSTEM CONNECTOR
subwoofer.
Downloaded From TheatreSystem-Manual.com Manuals
3 Assemble the AM loop antenna.
a b
a. Bend the stand in the direction indicated by the arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
4 Connect the AM and FM antennas
a. Connect one wire of the AM loop antenna to each AM
2
antenna terminal .
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
1
3
b. Push the FM antenna plug onto the center pin of the
FM antenna socket.
6 Connect the subwoofer cable.
• Just below the subwoofer speaker, to the left of
center, you should see the subwoofer connecting
cable. Plug this into the SUBWOOFER SPEAKER
terminal.
Caution
• These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
• Do not connect any speakers other than those
supplied to this system.
• Do not connect the supplied speakers to any
amplifier other than the one supplied with this c
system. Connection to any other amplifier may result
in malfunction or fire.
• The center speakers and front/surround speakers are
designed with different impedance values. Be sure to
identify and connect the speakers correctly since
improper connections may result in degraded sound
or operation.
1
.
2
02
En