Setting The Time - Lorex L23WD SERIES Instruction Manual

SETTING THE TIME

It is highly recommended to set the time on the system before doing any recording. The time can
be synchronized to a Network Time Server, or can be set manually. For details on configuring the
system time menu, see "System" on page 63.
Figure 6.0 Time menu.
To set the date and time:
1. Click (SETUP) in the status bar.
• The Setup window opens.
2. Click SYSTEM SETUP.
• The Main window opens.
3. Click SYSTEM.
• The System window opens.
4. Perform one of the following:
• Under NETWORK TIME SERVER SETUP, click SYNC. to synchronize the system to the network
time server (the system must be properly connected to your network in order to use this
function)
OR
• Under DATE TIME, manually select the date and time (yyyy/mm/dd; hh/mm/ss) and adjust
using the buttons.
If desired, change the Date Format and the Time Format.
NOTE:
5. Click APPLY and then click CLOSE to save your changes.
ATTENTION: If the saved time is earlier than the current time on the system, you will be
warned that overlapped data will be erased. Select YES and press ENTER to accept the
changes. Please allow a few moments for the overlapped video data to be deleted.
Setting the Time
35