MIMAKI CG-60SL Supplement For The Basic Operation Manual

Cutting plotter

Hide thumbs Also See for CG-60SL:

See also: Operating Manual , Quick Reference Manual

Supplement for the Basic Operation manual

The following functions are added from firmware version 1.80.

Please read this manual and fully understand it before using the device.

Make The Media Without Uncut Area ................................................................................ 2

Other Convenient Settings ............................................................................................... 3

Error Message ................................................................................................................... 4

This manual correspond to the models as firmware version 1.80 or later.

When turning on the power, you can confirm the firmware version.

If you have any question, contact your local distributor.

Table of Contents

MIMAKI ENGINEERING CO., LTD.

D202064-10

Table of Contents

Need help?

Do you have a question about the CG-60SL and is the answer not in the manual?

Page 1 Make the media without uncut area ................2 Other Convenient Settings ....................3 Error message ........................4 This manual correspond to the models as firmware version 1.80 or later. When turning on the power, you can confirm the firmware version. MIMAKI ENGINEERING CO., LTD. D202064-10...
Page 2 Make the media without uncut area By over wrapping the start point and the end point arbitrarily, you can make the media without uncut area. Over cut Specify the over cut function (valid/invalid) and the length of the over cut. part If the length of the over cut is set, when cut starts, cut will be performed from the position to the front by the specified length and the tool will move...
Page 3 Other Convenient Settings The setting items are added in the "Other Convenient Settings" of the Operation Manual page.3-59. The following three items are added. Function name Outline Setting values Over Cut Make the media without uncut area. OFF/ 0.1 to 1.0 mm mode switches standby condition of the local...
Page 4 Error message The error message is added. If the following message appears, take an appropriate remedy according to the table below. If the remedy does not work, contact your distributor or an sales office of MIMAKI. Error message Cause Remedy...
Page 6 Memo...