Intel NUC Kit DC3217IYE User Manual page 4

Intel NUC Kit DC3217IYE User Guide
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
Removing SO-DIMMs
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer's cover.
5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of
the socket.
6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-static
package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets.
8. Replace the computer's cover and reconnect the AC power cord.
Installing a Mini-PCIe Wireless Adapter
Only the following wireless adapters have been evaluated for regulatory compliance for use with the Intel
NUC Kit DC3217IYE in all regions:

Intel® Centrino® Advanced-N 6235
 Intel® Centrino® Advanced-N 6205
 Intel® Centrino® Wireless-N 2230
 Intel® Centrino® Wireless-N 2200

Intel® Dual Band Wireless-AC 7260 + Bluetooth*
 Intel® Dual Band Wireless-N 7260 + Bluetooth
 Intel® Dual Band Wireless-N 7260
 Intel® Wireless-N 7260 + Bluetooth
4