Electric Chainsaw - Hyundai HYC36LI User Manual

3.1.4.4.
unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
3.1.4.5.
breakage of parts and any other condition that may affect the power tools operation. If
damaged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
3.1.4.6.
cutting edges are less likely to become jammed and are easier to control.
3.1.4.7.
instructions, taking into account the working conditions and the work to be performed.
Using the power tool for operations other than those intended could result in a
hazardous situation.
3.1.5. Service.
3.1.5.1.
replacement parts. This will ensure that the safety of the power tool is maintained.

4. ELECTRIC CHAINSAW

4.1. Safety warning.
4.1.1. Keep all parts of the body away from the saw chain when the chain saw is operating. Before
you start the chain saw, make sure the saw chain is not contacting anything. A moment of
inattention while operating chain saws may cause entanglement of your clothing or body with
the saw chain.
4.1.2. Always hold the chainsaw with your right hand on the rear handle and your left hand on the
front handle. Holding the chain saw with a reversed hand configuration increases the risk of
personal injury and should never be done.
4.1.3. Wear safety glasses and hearing protection. Further protective equipment for head, hands,
legs and feet is recommended. Adequate protective clothing will reduce personal injury by
flying debris or accidental contact with the chain saw.
4.1.4. DO NOT operate a chain saw in a tree. Operation of a chain saw while up a tree may result
in personal injury.
4.1.5. Always keep proper footing and operate the chain saw only when standing on fixed, secure
and level surface. Slippery or unstable surfaces such as ladders may cause a loss of balance or
control of the chain saw.
4.1.6. When cutting a limb that is under tension be alert for spring back. When the tension in the
wood fibres is released the spring loaded limb may strike the operator and/or throw the chain
saw out of control.
4.1.7. DO NOT use for cutting brush and saplings. The tender slender material may catch the saw
chain and be whipped toward you or pull you off balance.
Store idle power tools out of the reach of children and do not allow persons
Maintain power tools. Check for misalignment or obstruction of moving parts,
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
Use the power tool, accessories and tool bits etc. in accordance with these
Have your power tool serviced by a qualified repair person using only identical
The safety rules must be observed during machine use. Before starting the
machine, read the instructions regarding personal safety and the safety of
unauthorized persons. Keep the instructions in a good state for future use
Page 6 Rev 2