STEINEL is 360 d trio Operating Instructions Manual page 8

Principle
Lights, alarms, and many Whether a house door,
other things triggered by garage, patio or carport,
movement - for your con- stairs, a storeroom or cellar
venience and safety. are involved, this infrared
The IS 360 D TRIO motion and switches on connected
sensor is equipped with consumers (e.g. a light). No
three 120° pyro sensors heat radiation is detected
which detect the invisible through obstacles, such as
heat emitted by moving walls or glass and no switching
objects (pedestrians, animals therefore occurs. Pyro sensors
etc.). The heat thus detected have a detection angle of 360°
is electronically converted with an opening angle of 180°.
Area monitored Reach max. 12 m
approx. 300 m 2
approx. 5 m max. 12 m
ca.5m
ca.12m
14
motion detector is rapidly
installed and ready for oper-
ation anywhere.
12 m
Important: the safest
motion detection is
obtained when the device
is mounted and aligned
laterally to the walking
direction and no obstacles
(such as trees and walls,
for example) obstruct the
view.
Functions
After the motion detector be switched on.
has been connected and Two setting options are
installed, the unit can available after removing
Switch-off delay
(time setting)
The desired period of opera-
tion of the light can be
adjusted continuously from
approx. 10 sec. to a max. of
15 min. When the adjustment
screw is at the left stop posi-
tion 1 , this means the short-
est time of approx. 10 sec.
When the adjustment screw
approx. 10 sec.-max. 15 min. is at the right stop position
6 , this means the longest
Twilight setting
The desired motion detector
response threshold can be
adjusted continuously from
approx. 2 lux to 2000 lux.
When the adjustment screw
is at the left stop position
this means daytime opera-
tion of approx. 2000 lux.
When the adjustment screw
is at the right stop position
6 , this means twilight
2 - 2000 lux
Reach setting/adjustment
Assuming an installation False switching by cars and
height of 2.5 m, the maxi- pedestrians, etc. is there-
mum reach of the sensor fore ruled out, or risk areas
is 12 m. Optimum adjust- deliberately monitored.
ment of the detection The shrouds
zone is possible according divided vertically or horizon-
to needs. tally along the grooved divi-
The shrouds 6 provided sions, or cut with scissors
serve to cover any desired 6 . After removing the deco-
number of lens segments rative ring
and individually reduce the are to be suspended on the
reach. upper part of the sensor
the decorative ring
time of approx. 15 min.
(factory setting is at min.).
The shortest time setting is
recommended when adjust-
ing the detection zone and
performing a functional test.
operation of approx. 2 lux.
(factory setting is daytime
operation.) The adjustment
screw must be at the left
stop position when setting
1 , the detection zone and for
the functional test in
daylight.
lens. The decorative ring
is subsequently to be reap-
plied and the shrouds
fixed firmly in place. Fine
6 can be
adjustment is also possible
by turning the sensor cas-
ing by ± 10° 3 .
2 , the shrouds
2 .
2
6 are
15