Canon ip110 series Online Manual page 416

2. Press and hold the Wi-Fi button, then release the button when the Alarm lamp flashes 3 times.
When the POWER lamp changed from flashing to lit, the access point mode is enabled.
Is the printer selected to connect external communication devices (e.g.
Check3
computers, smartphones, or tablets)?
Select an access point name (SSID) specified for the printer as a destination for external communication
devices.
Enter a password if you specify it for the printer.
Check4
Make sure that external communication devices are not placed far away from
Check5
the printer.
Do not locate external communication devices too far away from the printer.
Make sure that there is no obstruction.
Check6
Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices.
Make sure that there is no source of radio wave interference in your vicinity.
Check7
If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed
nearby, the device may cause interference. Place the wireless station as far away from the interference source
as possible.
Are you trying to connect 6 devices or more?
Check8
You can connect up to 5 devices using the access point mode.
Cannot Print from a Computer Connected to the Network
Make sure that the network settings of the computer are correct.
Check1
For the procedures to set up the computer, refer to the instruction manual of your computer or contact its
manufacturer.
If the printer driver is not installed, install it.
Check2
Install the printer driver with the Setup CD-ROM or install it from our website.
Make sure that access control is not set to the access point.
Check3
For the procedures to connect an access point and set it up, refer to the instruction manual of your access
point or contact its manufacturer.
Note
• To check the MAC address or the IP address of the computer, see
Address of the
Downloaded from ManualsPrinter.com Manuals
Computer.
Checking the IP Address or the MAC
416