Hitachi C 12RSH2 Instruction Manual page 33

Fence
Ⓐ
(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 36 (see Fig. 41; tilt the head to
the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (Ⓑ in Fig. 35) contacts the fence
as indicated Fig. 43.
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 36 (see Fig. 42; tilt the head to
the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (Ⓐ in Fig. 35) contacts the fence
as in Fig. 42.
Head
Bevel angle scale
4
Miter angle scale
Turntable
Ⓑ
Table on base
Fig. 39
1
Fence (A)
Base
Fig. 41
Fence
Ⓑ
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Bevel angle scale
Fence (B)
3
Base
English
Ⓐ
Table on base
Fig. 40
Head
2
Miter angle scale
Turntable
Fig. 42
33