Hitachi C 12RSH2 Instruction Manual page 32

English
To process crown molding at
positions 1 and 4 in Fig. 36.
Type of Crown
Molding
Miter Angle
Setting
right 35.3°
45° Type
( mark)
right 31.6°
38° Type
( mark)
(1)
Setting to cut crown moldings at positions 1 and 4 in Fig. 36 (see Fig. 37; tilt the motor
head to the left):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (Ⓐ in Fig. 35) contacts the fence
as indicated in Fig. 39.
(2) Setting to cut crown moldings at positions 2 and 3 in Fig. 36 (see Fig. 38; tilt the head to
the left):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (Ⓑ in Fig. 35) contacts the fence
as in Fig. 40.
Head
1
Miter angle
Turntable
scale
Fig. 37
32
Bevel Angle
Setting
left 30°
( mark)
left 33.9°
( mark)
Bevel angle scale
4
Fence (A)
Base
To process crown molding at
positions 2 and 3 in Fig. 36.
Miter Angle
Setting
left 35.3°
( mark)
left 31.6°
( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Head
2
Fence (B)
Turntable
Bevel Angle
Setting
left 30°
( mark)
left 33.9°
( mark)
Bevel angle scale
3
Miter angle scale
Base
Fig. 38