Table of Contents
Advertisement
MODE 1 and 2 – Setpoint & DHW Operation
Adjust Menu (1 of 1)
Item Field
Access
Description
Factory
MODE
Installer
Select the operating mode for the control.
BOILER TARGET
Factory
Select the boiler target temperature for setpoint
Installer
operation.
BOILER MAXIMUM
Factory
Select the maximum boiler target water
temperature.
BOILER MINIMUM
Factory
Select the minimum temperature allowed for
the boiler target temperature.
FIRE DELAY
Select the amount of time required for combustion
Factory
pre-purging, ignition and the flame to be
established.
Factory
BOILER MASS
Select the thermal mass of the boiler.
Installer
STAGE DELAY
Factory
Select the minimum time delay between
Installer
stages. Note: This setting is not used in this application.
DIFFERENTIAL
Factory
Select the differential that the control is to use
when it is operating the boiler.
DHW BOILER TARGET
Factory
Select the boiler target temperature while
heating an indirect DHW tank.
DHW MODE
Select no priority (1) or priority (2) of indirect
DHW heating over space heating.
Factory
Note: This item is only available when MODE
is set to 1.
PUMP DELAY
Factory
Select the boiler pump purge time after shutting
off the burner.
TEMPERATURE UNITS
Factory
Select to display temperature in degrees
Installer
Fahrenheit or in degrees Celsius.
Range
1, 2, 3, 4, 5, 6, 7
Default = 3
OFF, 70 to 220°F
(OFF, 21 to 104°C)
Default = 180°F
(82°C)
120 to 225°F, OFF
(49 to 107°C, OFF)
Default = 180°F
(82°C)
OFF, 80 to 180°F
(OFF, 27 to 82°C)
Default = 140°F
(60°C)
0:00 to 3:00 minutes
Default = 0:10 min
(1 second incre-
ments)
1 (low mass)
2 (medium mass)
3 (high mass)
Default = 2
Au, 0:30 to 9:55 min
Default = Au
Au, 2 to 42°F
(Au, 1 to 23°C)
Default = Au
OFF, 70 to 220°F
(OFF, 21 to 104°C)
Default = 180°F
(82°C)
1, 2
Default = 1
OFF 0:20 to 9:55 min ,
On
Default = 0:20 min
°F, °C
Default = °F
Model SF-10 Control Instructions Manual
Settings
19
Advertisement
Table of Contents
