Carriage Cable - Oki Microline 3320 Maintenance Manual

3.3.9 Carriage Cable

(1) Remove the printhead (see 3.3.1).
(2) Remove the upper cover (see 3.3.4 (1) – (5)).
(3) Remove the gear case Assy (see 3.3.5).
(4) Remove the space motor (see 3.3.7).
(5) Remove the space rack (3.3.8).
(6) Remove two screws
and disconnect cable from connector
(7) Remove carriage cable
(8) To install, follow the removal steps in the reverse order.
Note on installation:
(1) Take care not to fold the carriage cable
cable
7
(2) Make sure that the paper end lever
mounting the Driver Board.
2
9
2
5
1
1
, release the driver board
1
from fasteners on frame.
7
when assembling into the fasteners.
A
0
8
6
and PCB sheet
2
, , , .
3 4 5 6
during installation. Curve slightly the carriage
7
will not contact the Paper end Sensor
A
7
3
7
Claw
4
3 – 13
by lifting clamp
9
Claw
,
8
when
0