Continuous - Mitsubishi Electric PL12AK User Manual

2-3. How to connect program timer
(1) Install the program timer next to the remote controller the same way as the remote controller is installed.
(2) Connect the program timer and the remote controller with a 5-wire cable as shown in the figure below
Connect to indoor unit
2-wire cable
SET
FILTER
MONITOR
CHECK MODE
TEST RUN
SET/MONITOR
PROGRAM TIMER
PAC-SC32PTA
4
Use 5-wire cable
Connect to CN1
2-4. Names and functions
<PAC-SC32PTA>
WEEKLY TIMER SETTING DISPLAY
Set timer for a week.
SET/MONITOR DISPLAY
During SET is display, clock adjustment,
change of weekly day, daily and weekly timer
setting can be performed.
During MONITOR is display, all switches
except SET/MONITOR SW are invalidated.
This is normal status.
WEEK DAY SETTING SW
Used for week day setting.
MODE SELECTOR SW
Using this switch select "MONITOR" or "SET"
Mode.
"MONITOR" :Indicates the current timer set-
ting. All switch expect MODE
SELECTOR SW are invalidated
then.This is the normal status.
"SET": Set to "SET" mode for clock adjustment,
charge of week day, daily and weekly
timer setting.
NOTE:While the program timer is connected to the remote controller, the
24hour ON/OFF timer on the remote controller will not operate.
SET BACK
S M T W T F S
0 3 6 12 15
12 15 18 21 24
WEEKLY
DAILY
TODAY SET BACK ON
SETTING SETTING
ON SET BACK
CLOCK OFF DAILY TIMER OFF
Connect to CN1
CURRENT TIME DISPLAY
During MONITOR status,current
time is display.
During Daily timer setting, a
time desire for timer setting is
displayed.
S M T W T F S
SET
MONITOR
SET/MONITOR TODAY
CLOCK
PROGRAM TIMER
PAC-SC32PTA
CLOCK ADJUSTMENT SW
Used for adjustment of the current time.
Push SW to advance the time. Each time the button is
pushed the time advance by 1 minute, pushing continuously
advances by 1 minute at 0.5 second interval, and when the lower
digit of minute becomes 0 indication advances in 10 minutes
unit.
SW is used for reversing the time. Each time the button is
pushed the time reverses by 1 minute, pushing continuously
reverses the time by 1 minute at 0.5 second interval, and when
the lower digit of minute becomes 0 indication reverses in 10
minutes unit.
OC246-57
SET BACK DISPLAY
Indicates the set back
range.
SET BACK
0 3 6 12 15
12 15 18 21 24
WEEKLY
DAILY
SETTING
SET BACK ON SETTING
ON SET BACK
DAILY TIMER OFF
OFF
DAILY TIMER SETTING DISPLAY
24 hours is divided into 48 blocks and each
block express 30 minutes.
The block display consists of 3 pattern.
Set back
1=2°F 2=4°F 3=6°F 4=8°F.
SET BACK SETTING SW
Used for set back setting.
ON/SET BACK/OFF SW
Used to specify the time setting pattern.
DAILY TIMER SW
Used for timer setting in 30 minutes unit.
WEEKLY TIMER SW
Used for setting timer in day of week unit.
Pushing SW moves the week day light
display in order of
W ...
S M T
enabling to set the week day.