Makita 9561CR Instruction Manual page 8

To start the tool, slide the slide switch toward the "I (ON)"
position. For continuous operation, press the front of the
slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
Indication lamp
For Models 9561CVR,9562CVR,9564CVR,9565CVR
1
009461
For Models 9561CR,9562CR,9564CR,9565CR
1
009416
The indication lamp lights up green when the tool is
plugged. If the indication lamp does not light up, the
mains cord or the controller may be defective. The
indication lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn out,
or the controller, the motor or the ON/OFF switch may be
defective.
Unintentional restart proof
The tool does not start with the switch being lock-on
even when the tool is plugged.
At this time, the indication lamp flickers red and shows
the unintentional restart proof device is on function.
To cancel the unintentional restart proof, return the slide
switch to "O(OFF)" position, then release it.
1. Indication lamp
(speed
adjusting dial)
1. Indication lamp
8
Speed adjusting dial
For 9561CVR,9562CVR,9564CVR,9565CVR
2
001046
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained when
it is turned in the direction of number 1.
Refer to the below table for the relationship between the
number settings on the dial and the approximate rotating
speed.
Number
1
2
3
4
5
010478
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Electronic constant speed control
•
Possible to get fine finish, because the rotating
speed is kept constantly even under the loaded
condition.
Soft start feature
•
Soft start because of suppressed starting shock.
Overload protector
•
When the load on the tool exceeds admissible
levels, power to the motor is reduced to protect the
motor from overheating. When the load returns to
admissible levels, the tool will operate as normal.
1. Speed adjusting
dial
1
min -1 (R.P.M.)
2,800
4,000
6,500
9,000
12,000