Onkyo HT-R695 Basic Manual page 45

> Specifications > Settings
7� Miscellaneous
Change the frequency step for the tuner, update the firmware, and perform Initial Setup,
etc.
■ 1� Tuner
Setting Item Default Value
AM / FM 10 kHz / 0.2 MHz Select a frequency step depending on your area of
Frequency Step
(North American
models)
AM Frequency 9 kHz
Step (European,
Australian and
Asian models)
■ 2� Remote ID
Setting Item Default Value
Remote ID 1
> Listening Modes > Playback Function
Setting Details
residence.
Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz".
• When this setting is changed, all radio presets
are deleted.
Select a frequency step depending on your area of
residence.
Select "10 kHz" or "9 kHz".
• When this setting is changed, all radio presets
are deleted.
Setting Details
Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other ONKYO components that are
installed in the same room. After changing the ID
on the main unit, change the ID on the remote
controller accordingly with the following procedure.
While holding down MODE, press the following
buttons for about 3 seconds.
• To change the remote controller ID to "1":
(The remote indicator flashes once.)
• To change the remote controller ID to "2":
(The remote indicator flashes twice.)
• To change the remote controller ID to "3":
(The remote indicator flashes three times.)
■ 3� Firmware Update
Setting Item Default Value
Update Notice Enable
Version
‐
Update via
‐
NET
Update via
‐
USB
• Wait for a while if "Firmware Update" cannot be selected. It will appear when the network feature is
started.
■ 4� Initial Setup
You can make the initial setup from the setup menu.
• Wait for a while if "Initial Setup" cannot be selected. It will appear when the network
feature is started.
■ 5� Lock
Setting Item Default Value
Setup Parameter Unlocked
> Basic Manual
Troubleshooting | Appendix
Setting Details
Availability of a firmware update will be notified via
network.
"Enable": Notify updates
"Disable": Do not notify updates
The current firmware version will be displayed.
Press ENTER to select when you want to update
the firmware via network.
• You will not be able to select this setting if you
do not have Internet access or there is nothing
to update.
Press ENTER to select when you want to update
the firmware via USB.
• You will not be able to select this setting if a
USB storage device is not connected or there is
nothing to update in the USB storage device.
Setting Details
Lock the Setup menu to protect the settings.
"Locked": The menu is locked.
"Unlocked": The menu is unlocked.
21