Onkyo HT-R695 Basic Manual page 37

> Specifications > Settings
3� Audio Adjust
Make advanced settings such as those related to multiplex audio, settings for the LFE level,
or those related to the volume of this unit.
■ 1� Multiplex/Mono
Setting Item Default Value
Multiplex Input Main
Channel
Mono Input Left + Right
Channel
■ 2� Dolby
Setting Item Default Value
Loudness On
Management
> Listening Modes > Playback Function
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
• If multiplex audio is being played, "1＋1" will be
displayed when on the remote controller is
pressed.
Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right" : Left and right channels
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": Use this function
"Off": Do not use this function
■ 3� LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series, Multichannel
PCM, and DSD signals.
Setting Item Default Value
LFE Level 0 dB
■ 4� Volume
Setting Item Default Value
Mute Level
－∞dB
Maximum Volume Off
Power On Volume Last
Headphone Level 0 dB
> Basic Manual
Troubleshooting | Appendix
Setting Details
Select the low-frequency effect (LFE) level of each
type of signal from "0dB" to "－∞dB". If the low-
frequency effect sound is too strong, select
"－20dB" or "－∞dB".
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "－∞dB",
"－40dB", and "－20dB".
Set the maximum value to avoid too high volume.
Select a value from "Off", "50" to "99".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "1" to "99" and
"Max".
• You cannot set a higher value than that of
"Maximum Volume".
Adjust the output level of the headphones. Select a
value between "－12 dB" and "＋12 dB".
13