Onkyo HT-R695 Basic Manual page 43

> Specifications > Settings
Setting Item Default Value
Pairing
‐
Information
Device
‐
Status
‐
• Wait for a while if "Bluetooth" cannot be selected. It will appear when the BLUETOOTH function is
started up.
> Listening Modes > Playback Function
Setting Details
You can initialize the pairing information saved on
this unit.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored in this unit.
• This function does not initialize the pairing
information on the BLUETOOTH enabled
device. When pairing the unit again with the
device, be sure to clear the pairing information
on the BLUETOOTH enabled device in
advance. For information on how to clear the
pairing information, refer to the BLUETOOTH
enabled device's instruction manual.
Displays the name of the BLUETOOTH enabled
device connected to the unit.
• The name is not displayed when "Status" is
"Ready" and "Pairing".
Displays the status of the BLUETOOTH enabled
device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
■ 4� Power Management
Setting Item Default Value
Sleep Timer Off
Auto Standby On/Off
Auto Standby in (Off)
HDMI Standby
Through
USB Power Out Off
at Standby
> Basic Manual
Troubleshooting | Appendix
Setting Details
Allows the unit to enter standby automatically when
the specified time elapses. Select a value from "30
minutes", "60 minutes", and "90 minutes".
"Off": Does not turn the unit to standby
automatically.
This setting places the unit on standby
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power
Out at Standby" or "Network Standby" is on, this
becomes the HYBRID STANDBY mode which
reduces the increase in power consumption to a
minimum.)
"On": The unit will automatically enter standby
mode ("AUTO STBY" will light).
"Off": The unit will not automatically enter standby
mode.
• "Auto Standby" is displayed on the display and
TV screen 30 seconds before the Auto Standby
comes on.
• "Auto Standby" does not work when Zone 2 is
active.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
• This setting cannot be set to "On" if "Auto
Standby" is set to "Off".
Devices connected to the USB port are supplied
with electricity even when this unit is in standby
mode when this function is "On".
• When using this feature, power consumption
increases even when the unit is on standby,
however, the increase in power consumption is
kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only essential
circuits are operating.
19