Power On, Suspend, Wake Up And Power Off; Calibrating The Screen - Newland NLS-PT30 Series User Manual

Power On, Suspend, Wake Up and Power Off

 Power On:
Press and hold the Power key for 2-3 seconds to turn the terminal on.
 Suspend:
When the terminal is powered on, pressing the Power key down for 2 seconds will suspend the terminal.
If no operation is performed on the terminal for some time, it will go into suspend mode (in the case that auto suspend
is already enabled).
The timer for auto suspend can be set by:
Tap "Start"→"Settings"→"ControlPanel"→double-tap "Power"→"Schemes".
 Wake Up:
When the terminal in suspend mode, press the Power key to wake up the terminal.
 Power Off:
Tap "Start"→"Shutdown"→"Shutdown". The terminal will backup user data before shutdown.

Calibrating the Screen

The calibration tool is for calibrating the touch screen.
Tap "Start"→"Settings"→"ControlPanel"→ double-tap "Stylus"→"Calibration".
Click "Recalibrate" button then the screen becomes as shown in Figure 2.2.Carefully press and briefly hold the tip of stylus
on the center of each target that appears on the screen. Repeat as the target moves around the screen then tap the
screen to continue.
Figure 2.1: Calibration Figure 2.2: Recalibrate
6