Power On, Suspend, Wake Up And Power Off; Calibrating The Screen - Newland NLS-PT30 Series User Manual

Power On, Suspend, Wake Up and Power Off

 Power On:
Press and hold the Power key for 2-3 seconds to turn the terminal on.
 Suspend:
When the terminal is on, holding down the Power key for 2 seconds will suspend the terminal.
If no operation is performed on the terminal for some time, it will go into the suspend mode (in the case that auto
suspend is already enabled).
To set the timer for auto suspend, go to "Start"→"Settings"→"Control Panel"→
 Wake Up:
When the terminal in the suspend mode, press the Power key to wake it up.
 Power Off:
Tap "Start"→"Shutdown"→"Shutdown" to turn off the terminal. The terminal will backup user data before it shuts down.

Calibrating the Screen

The calibration tool is for calibrating the touch screen.
Tap "Start"→"Settings"→"Control Panel"→ double-tap
Click "Recalibrate" button then the screen becomes as shown in Figure 2.2.Carefully press and briefly hold the tip of stylus
on the center of each target that appears on the screen. Repeat as the target moves around the screen, then tap the
screen to continue.
7
Figure 2.1: Calibration
→"Schemes".
→ tap "Calibration".
Figure 2.2: Recalibrate