Charging The Battery; Power On, Suspend And Wake Up; Calibrating The Screen - Newland NLS-PT980-II Series User Manual

1. Figure 1 indicates the direction to unlock the latch.
2. Figure 2 indicates the direction to take out the battery cover.
3. Follow the instructions of figure 3 and 4 to insertthe battery.
4. Follow the instructions of figure 5to close down the battery cover.
5. Push the latch to the lock position.

Charging the Battery

There are two ways to charge the battery:
 Using USB cable to connect to host PC. Charging time should need around 8-10 hours.
 Using AC adaptor to connect to the terminal with the appropriate power source. Charging time should need around 4
hours.
Charging indication: Charging status LED turn from red to green, indicates the battery charging complete.
Note: standby battery can only be charged using provided adapter. It take about 4 hours to charge fully.

Power On, Suspend and Wake Up

 Power On:
Long press the power button for 2-3 seconds to start the terminal.
 Suspend:
During terminal in power on status, long press the power button for 2 seconds to turn terminal into suspend mode
immediately.
Terminal no operation in a period of time will go into suspend mode, when you turn on the auto suspend function.
The timer for automatically into suspend mode can be set by:
Tap "Start"→"Settings"→"Control Panel"→double clicks "Power"→"schemes".
 Wake Up:
During terminal in suspended status, press power button to wake up the terminal.

Calibrating the Screen

The touch screen calibration tool is for setting accuracy of the touch screen.
Tap "Start"→"Settings"→"Control Panel"→ double clicks "Stylus"→"Calibration".
Click "Recalibrate" button then the screen becomes as shown in Figure 2.2. Carefully press and briefly hold the tip of
stylus on the center of each target that appears on the screen. Repeat as the target moves around the screen then tap
the screen to continue.
5