Diagrams; Note For Printed Wiring Boards And Schematic Diagrams - Sony HCD-LS1 Service Manual

5-1.

NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Through hole.
z
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
SECTION 5

DIAGRAMS

Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• 2 : nonflammable resistor.
• C : panel designation.
Note: Note:
The components identi- Les composants identifiés par
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti- pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part pièce por tant le numéro
number specified. spécifié.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : TUNER (FM/AM)
J : CD PLAY
E : TAPE
• Circuit Boards Location
POWER SW board
FRONT board
TACT SW board
DOOR SW board
TRA ASSY V619
21 21
MAIN board
TUNER (FM/AM)
RELAY board
JACK board
PHOTO JACK board
AMP board
POWER SUPPLY board
AC board
MAIN R237 board