Changing The Battery; Secondary Control; Remote Control Problem - PEUGEOT 208 Handbook

Secondary control

doors in the event of a fault with the central
locking system or a battery failure.
Driver's door
Insert the key in the lock to lock or unlock
the door.
Passenger doors
On the rear doors, check that the child lock
is not on.
Remove the black cap located on the edge
of the door, using the key.
Insert the key into the aperture without
forcing, then without turning, move the
latch sideways towards the inside of the
door.
Remove the key and refit the cap.

Remote control problem

Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
First of all, use the key in the lock to unlock
or lock your vehicle.
Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
Reinitialisation
Switch off the ignition.
Turn the key to position 2 (Ignition).
Press the closed padlock immediately
for a few seconds.
Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again.

Changing the battery

Battery ref.: CR1620 / 3 volts.
If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
Unclip the cover using a screwdriver in the
cutout.
Remove the cover.
Extract the flat battery from its location.
Place the new battery into its location
observing the original direction.
Clip the cover in place.
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Access
2
49